Hazard function (4 turn indicators)
The Hazard function turns all four turn indicators on
at the same time to signal an emergency condition.
This function is activated by pressing (6).
When the Hazard function is active, all four turn
indicators blink at the same time as well as the
warning lights on the instrument panel.
activating the "Hazard" function, if motorcycle
is switched OFF (key set to OFF), the function will
stay active until manually disabled by user or it will
be automatically disabled 1 hour to save
charge.
In it is not possible to activate the Hazard
function.
Note
If user a Key-ON while the "Hazard"
function is still active, the function will remain ON
(temporary turn indicator control interruption is
allowed during the instrument panel initial check
routine).
Note
If there is a sudden interruption in the
while the function is active, the instrument panel will
disable the function when the voltage is restored.
Note
The "Hazard" function has higher priority
compared to normal operation of the single turn
indicators, this means that, as long as it is active, it
will not be possible to activate the single right or
turn indicators.
Fig 75
98
To Next Page
Loading...
Need help?
General
