12) Check knife changing switch by turning the switch to the #1 position and pressing the two
yellow button the knife will go down and stay down then turn the switch to #0 and the knife will
go back up if so it is ok, if not go to the maintenance manual on page 4.3, valve adjustment #9
13)
Write the program parameters down on paper by pressing program then #0 then pressing the
# 1,2,3,4, buttons, then press end Then go thought # 1 -
8 and by pressing next Jill you get to the
end of the parameters press the next or last twice then press reset to return to the main program
14)
Now install the two side tables on the machine The instruction are on page 9 & 10.
15) Perform a visual inspection (cover and overall appearance) if all looks good, you may sign
off on the installation / Q.C. form
https://www.supplychimp.com
To Next Page
Loading...
Need help?
General
