How To Adjust The Full Maximum Paper Cutting Ability
Take a full stack of heavy paper stock and place it into the cutter and make a cut, if it cuts all the
way thought then you are ok, but if does not cut all the way thought then you have to do the
following:
1) Take the top back cover off
2)
Adjust the clamp pressure top position switch, by loosening the allen screw on the long arm
of the switch and moving it more down towards the clamp and do this a little at a time
3) Make a cut every time you adjust the long arm do this till you can cut all the way thought the
stock
https://www.supplychimp.com
To Next Page
Loading...
