Why is the stitch not at right angles to paper on my Duplo DBM-600?
If the stitch is not at right angles to the paper on your Duplo Folding Machines, it's likely that the angle of the saddle-stitching stopper is not appropriately adjusted. Adjust the angle of the saddle-stitching stopper.
Why are stitches deformed on my Duplo DBM-600?
If the stitches are deformed on your Duplo Folding Machines, the stitcher head is not appropriately adjusted. Adjust each section of the stitcher head.
Why does Duplo DBM-600 Folding Machines paper not reach the folding stopper and paper jams?
If paper does not reach the folding stopper and jams on your Duplo Folding Machines, the space under the fold paper holder may be too narrow for the paper thickness. Widen the space.
Why is the surface of a booklet stripped at the press roller of Duplo Folding Machines?
If the surface of a booklet is stripped at the press roller of your Duplo Folding Machines, the fold ejection roller gap is too narrow. Increase the gap.
Why is my Duplo Folding Machines booklet not conveyed after being trimmed?
If your Duplo Folding Machines booklet is not conveyed after being trimmed, the conveyance restart timing is not appropriate. Make the timing slower.
Why is the booklet not in contact with the stopper on my Duplo DBM-600?
If the booklet is not in contact with the stopper because it either doesn't reach it or bounces off on your Duplo Folding Machines, the conveyance stop timing is not appropriate. Make the conveyance stop timing slower on the control panel of the DBM-600 or the PC CONTROLLER. If the problem persists, narrow the roller gap.
General| Brand | Duplo |
|---|---|
| Model | DBM-600 |
| Category | Folding Machines |
| Language | English |
Describes critical safety devices like emergency stop and interlock switches for machine protection.
Explains how to adjust the distance between stitches for optimal results.
Provides detailed procedures for safely powering the machine on and off.
Guides users through configuring standard and custom sizes, binding methods, and trimming settings.
Explains how to perform section-specific adjustments using the step mode.
Lists and explains error codes, messages, and icons for the DBM-600.
Lists and explains error codes, messages, and icons for the DBM-600T.
Provides detailed steps for clearing paper jams in both DBM-600 and DBM-600T.
Addresses common issues like machine not turning on and specific section problems.
Troubleshoots issues with finished booklets such as skewing or misalignment.
To Next Page
