3-21
Chapter 3 ADVANCED OPERATION
Rough
adjustment knob
8
Move the rough adjustment knob of
the second folding plate to the upper
end.
●
The rough adjustment knob cannot
be turned either clockwise or coun-
terclockwise. Make sure that you pull
up the knob when you want to move
it. ( p.2-4)
●
After moving the rough adjustment
knob, turn the ne adjustment knob
to the right and left a few times to
check that it moves slightly. ( p.2-5)
Stacker roller
9
Move the stacker rollers to the ap-
propriate position.
The machine shown in the gure to the
right is a North America model.
Refer to the table of stacker rollers position
attached to the control panel section (for
EU) or to the paper receiving tray (for North
America) for their appropriate position (
p.3-13).
For this example (A4/LT size, single fold),
move the stacker rollers to "3."
Top cover
10
Open the top cover.
Set screw
Paper feed ring
11
Loosen the set screw of the paper
feed ring.
12
Move the paper feed ring at the far
end to the folded line of the paper.
13
Tighten the set screw of the paper
feed ring.
To Next Page
Loading...
Need help?
General
