Duplo DP-S510 - Page 136

135
4
b Press Section ............................................................152
(1) Checking the Press Roller Sensor........................152
(2) Adjusting the Printing Area
(Press OFF Timing) ................................................... 153
n Paper Ejection Section.............................................154
(1) Adjusting the Paper Stripper
Finger Clearance..................................................154
m Drum Section .............................................................155
(1) Adjusting the Ink Amount...................................155
(2) Adjusting the Squeegee Gap................................156
(3) Adjusting the Master Clamp Margin ..................157
(4) Adjusting the Drum Rail Gap..............................157
, Electrical System.......................................................158
(1) Adjusting Reduction / Enlargement....................158
1. Adjusting M-mark Feed Volume Magnification ...158
2. Adjusting M-mark Speed Magnification..........158
3. Adjusting Scan Vertical Magnification.............159
4. Adjusting Scan Horizontal Magnification........159
(2) Master Making Start Position.............................158
(3) Reading Start Position.........................................161
1. Adjusting the Top End Reading
Start Position Adjustment procedure............161
2. Adjusting the Lateral (Operation Side)
Reading Start Position...................................161
(4) Adjusting the Master Making Start Position......162
1. When the Scanner Is in Use..............................162
2. When in Online..................................................162
(5) Adjusting the Document Reading Darkness.......163
1. Adjusting the Scan Level : Text mode ..............163
2. Adjusting the Scan Level : Text/Photo,
Photo/Text, Photo mode.................................163
(6) Adjusting of Printer Unit's Printing Speed.........164
1. Adjusting the Pre-stop Speed............................164
2. Adjusting the M-mark Speed............................164
3. Adjusting the Jog Speed....................................165
4. Adjusting the Print Speed.................................165
(7) Adjusting Paper Eject Speed ...............................166