Inserting a full bobbin
–
Insert a full bobbin in the upper part of the bobbin case 2.
–
Pull the thread through slit 5 under tension s pring 6.
–
Pull a thread length of approx. 4 cm out of the upper part of the
bobbin case.
When the thread is being pulled off, the bobbin must turn in the
direction of the arrow (in the opposite direction to the hook
rotation).
–
Insert the upper part of the bobbin case 2 with the full bobbin in the
lower part of the bobbin case.
–
Close the bobbin case retainer 1.
–
Put the fabric sliding sheet on again.
–
Switchthemainswitchon.
–
Start a new sewing cycle.
The stitch counting has been reset to the old value. (see
Programming Instructions “Adjusting programs)
20
65
21
To Next Page
Loading...
