DURKOPP ADLER 745-34 Speedpocket

2.14.1 Working method (Production of trousers)
Possible processing variants
–
Front trousers pockets with pocket bag positioned below
–
Hind trousers pockets with or without flap, with pocket bag
positioned below
Positioning method
Example: Hind trousers without flap, with pocket bag positioned below
1st step:
–
Select the pocket program on the control panel
–
Push the pocket bag under pocket bag clamp 1 and position it at
the marks 2.
As marks you can use e.g. adhesive tape attached to the fabric
sliding sheet.
2nd step:
–
Position hind trousers at the “rear positioning point” 4 and at
mark 3.
–
Touch the pedal.
The hind trousers is firmly clamped in its position by the fabric
downholder 5.
–
Smooth out the clamped hind trousers in the area of the dart.
3rd step:
–
Touch the pedal.
The feeding clamps run forward and lower onto the workpiece. A
separate lowering of the clamp halves can be programmed.
For example: the right clamp lowers and the fullness from the
trousers is manually smoothed out to the left. Then lower the left
clamp.
–
Position the piping strip 7 on the feeding clamps flush at the front
edges 8.
The alignment of the various piping types on the feeding clamps is
described more precisely in the following.
See“Positioningthepipingstrip”.
–
Touch the pedal.
The folder 6 lowers.
–
Touch the pedal once again.
Thesewingcyclestarts.
30