6.6 Winding on the hook thread
The separate bobbin winder makes it possible to wind the hook thread
independently from the sewing operation.
–
Remove remaining thread from the bobbin hubs before winding.
–
Put the thread reel on the thread stand.
–
Thread the thread through the drill-hole 1 of the unwinder arm.
–
Conduct the thread through threading guide 4.
–
Conduct the thread through the bobbin thread tension 2.
–
Wind up the thread to the right.
Press the bobbin retainer 3 against the bobbin hub.
The bobbin winder starts.
After reaching the set bobbin filling level the bobbin winder stops
automatically.
See Service instructions for setting the bobbin filling level.
1
15
43 2
1
To Next Page