No. 60027, Issue 4. January 1998
7 Programming 29
7.2 DX Remote PCD Parameters
Note Refer to section 7.4 ‘Using the PCD’ for PCD operating instruction.
Parameters related to the SLM contained in the DX Remote program fall into two
categories : lighting parameters and Drive Program parameters.
7.2.1 Lighting Parameters
The lighting parameters must be enabled so that lights will operate (SLM-TÜV).
Parameter Purpose
Side Lights Enable If set to ‘yes’, sidelights (front and rear) are enabled.
State yes / no If set to ‘no’, there will be no response to a DX
Accessed by : OEM Remote sidelight button being pressed (other than a
beep for some varieties of remotes).
Indicators Enable As for the Side Lights Enable parameter
State yes / no
Accessed by: OEM
Hazard Enable As for the Side Lights Enable parameter
State yes / no
Accessed by: OEM
To Next Page
Loading...
Need help?
General
