9
CA 150 O150EN2
INSTRUMENTS AND CONTROLS, FUNCTIONAL DESCRIPTION
1 Horn, switch
2 Starter switch
3 Hazard beacon, switch
(Optional)
4 Working lights, switch
(Optional)
5 Reserve brake/Parking brake
6 Instrument protection
7 Warning lamp, battery
charging
8 Brake warning lamp
9 Warning lamp, oil pressure
10 Warning lamp, hydraulic filter
11 Warning lamp, air filter
12 Warning lamp, hydraulic
temperature
Items.in Designation Symbol Function
fig. 6
Press to sound the horn.
In position
the electric circuit is broken.
In position
all instruments and electric
controls are powered.
In position
the start motor is activated.
Turn right to switch on the hazard beacon.
Turn right to switch on the working lights.
Press to activate the reserve brake. Press
when the machine is stationary to activate the
parking brake.
Pull out to release both brakes.
Fold down over the instruments to protect
from weather and damage.
If this lamp lights while the engine is running,
the alternator is not charging.
Stop the engine and remedy the fault.
The lamp lights when the parking or reserve
brake knob is pushed in and the brakes are
applied.
The lamp lights if engine oil pressure is too
low. Stop the engine immediately and locate
the fault.
If this lamp lights while the engine is running at
full rev, the hydraulic filters must be changed.
If this lamp lights while the engine is running at
full rev, the air cleaner must be cleaned or
replaced.
If this lamp lights, the hydraulic fluid is too hot.
Do not drive the roller; cool the fluid by
allowing the engine to idle and locate the fault.
STOP
To Next Page
Loading...
