16
CA 150 O150EN2
STARTING
789
2
13
15
19
Starting the engine
Set the forward/reverse lever (19) in neutral. The
engine cannot be started if the lever is in any other
position.
Set the amplitude selector (13) for Low/High vibration to
O mode.
Set the revs control (15) to idling mode.
Turn the starter switch (2) to the right to the starting
mode and release the knob immediately when the
engine starts.
Do not run the starter motor too long. If the
engine does not start immediately, wait a
minute or so before making a new attempt.
Warm up the engine for a few minutes with the rev
control in the idling mode, longer if the ambient
temperature is below +10°C (+50°F).
Check while warming up that the warning lamps for oil
pressure (9) and charging (7) are out. The warning
lamp (8) for the parking brake should still light.
When you start up and drive a cold machi-
ne, the hydraulic fluid is cold, and the
braking distance will be longer than normal
until the machine reaches normal working
temperature.
Ensure that ventilation (extraction) is
adequate if the engine is run indoors.
Risk of carbon monoxide poisoning.
Fig. 15 Instrument panel
2. Starter switch
7. Charging lamp
8. Brake lamp
9. Oil pressure lamp/temperature
lamp
13. Amplitude selector
15. Revs control
19. Forward/Reverse lever
WARNING
WARNING
CAUTION
To Next Page
Loading...
