18
CA 150 O150EN2
18
13
DRIVING/VIBRATION
Engagement and disengagement of vibration is made
with the switch (18) on top of the forward/reverse lever.
Always switch off vibration before the roller comes to a
complete standstill.
Never allow vibration to be on when the roller
is stationary; this may damage the surface
and the machine.
Drum vibration can be set in two modes, selected using
the switch (13). Turn the knob to the left mode for low
amplitude, to the right mode for high amplitude.
Never alter the amplitude setting while the
vibration is running. Switch vibration off first
and wait until it has ceased before altering the
amplitude.
Fig. 17 Instrument panel
13. Amplitude selector
18. Vibration ON/OFF
Low/High amplitude
– Setting
CAUTION
CAUTION
To Next Page
Loading...
