23
CA 150 O150EN2
INSTRUCTIONS FOR TOWING
2
3
4
5
6
1
Fig. 27 Left frame side
1. Centre hole
2. Centre plug
Drum motor brake (Optional)
Screw off the center plug (2) of the drum brake, which
is accessible through the center hole (1) in the left side
of the frame.
Disengaging the drum brake
Fig. 28 Sectional view of brake housing
3. Bolt
4. Nut
5. Washer
6. Brake piston
Screw in the bolt (3) to the bottom according to the
figure. Now screw in the nut (4) so that it lies against
the washer (5) and then a further 11/2 inch while hold-
ing the bolt (3).
The brake is now disengaged and the roller can be
towed.
After towing, remember to reset the towing
valves (1). Unscrew the adjusting screw (4) to
its initial position 26 mm (1 inch) from the
contact surface, and tighten the lock nuts (3).
Also reset the brake of the drum motor.
CAUTION
To Next Page
Loading...
