Dynapac CA300 - Before Starting Procedures; Battery Disconnector Setup; Operators Seat Adjustment

14 CA300 O300EN1
BEFORE STARTING
Battery disconnecter
– Switching ON
Operator’s seat in cab and with
ROPS (Optional) – Setting
Fig. 10 Operator’s seat
1. Locking lever - length adjustment
2. Lever - weight adjustment
3. Seat belt
Fig. 8 Engine compartment
1. Battery disconnecter
2. Hourmeter
Adjust the operator’s seat to ensure a comfortable
posture and so that all controls are within easy reach.
The seat can be adjusted as follows:
• Length adjustment (1)
• Cushioning to suit weight of operator (2).
Always make sure that the seat is secure
before beginning operation.
Remember to use the seat belt (3).
Operator’s seat – Setting
Fig. 9 Operator’s seat
1. Locking lever - length adjustment
Adjust the operator’s seat to ensure a comfortable
posture and so that all controls are within easy reach.
The seat can be adjusted as follows:
• Length adjustment (1)
Always make sure that the seat is secure
before beginning operation.
Remember to carry out daily service. See maintenance
manual.
The battery disconnecter is located in the engine
compartment. Open the engine cover and set the key
(1) to the ON position. The entire roller will be powered.
The hourmeter (2) records the number of hours so long
as the engine is running.
The engine hood must be unlocked during
operation, so that battery power can be
disconnected quickly if necessary.
1
1
2
3
2
1