EasyManua.ls Logo

Dynapac DR6X - Final Shut-Down of Machine

Dynapac DR6X
114 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11.1 Final shut-down of machine
If the machine can no longer be used and needs to be finally shut
down you must carry out the following work and have the machine
disassembled by an of
ficially recognized specialist workshop.
DANGER!
Danger to life caused by explosive gas-air
mixes!
Do not allow gasoline to come into contact with
hot components.
Smoking and open fire is prohibited.
Keep gasoline away from heat sources, sparks
and other sources of ignition.
Do not spill any gasoline.
Components that previously contained gaso-
line must not be cut with a cutting torch.
WARNING!
Health hazard caused by fuels and lubricants!
Safety regulations and environmental protec-
tion regulations must be followed when han-
dling fuels and lubricants
Ä
Chapter 3.4 „Han-
dling fuels and lubricants“ on page 23.
Protective equipment:
n
W
orking clothes
n
Safety shoes
n
Protective gloves
n
Safety goggles
1. Empty the fuel tank.
2. Drain oil from engine and tamper foot.
Disposal – Final shut-down of machine
DR6X
110

Table of Contents