Dynapac DR6X - Operation in Trenches

To Next Page

To Previous Page

3.6.3 Operation in trenches

Applies only to Germany.

The vibratory tamper or the vibratory plate were tested outdoors by

BG Bau (Germany) regarding CO emissions. The tests were car-

ried out in a trench with a width of 1.5 metres, a depth of 3 metres

and a length of 10 metres.

These test showed CO emissions below the occupational exposure

limit (OEL) according to TRGS 900 when operating a maximum of

4 times 15 minutes per shift (8 hours).

For this reason, take care to ensure sufficient ventilation when

operating the vibratory tamper or vibratory plate in more than

shoulder-deep trenches which have a width of less than

1.5 metres, a maximum depth of less than 3 metres or a maximum

length of less than 10 metres.

Concerning your safety – Start-up procedure

DR6X