3.9 Maintenance work
3.9.1
Preliminary remarks
Adhere to the specified operating, maintenance and repair meas-
ures.
The machine must only be serviced by qualified personnel author-
ised by the operating company.
Keep unauthorised persons away from the machine.
Perform maintenance work only with the engine shut down and the
spark plug connector disconnected.
Make sure that the engine cannot be accidentally started during
maintenance work.
3.9.2 Working on the engine
Drain the engine oil at operating temperature – danger of scalding!
Wipe off spilled oil, catch running out oil and dispose of environ-
mentally.
When working on the air filter no dirt should fall into the air duct.
Do not work on the hot exhaust - danger of burning!
Store used filters and other oil contaminated materials in a sepa-
rate, specially marked container and dispose of environmentally.
3.9.3 Working on the tamper foot
Drain the tamper foot oil at operating temperature – danger of
scalding!
Wipe off spilled oil, catch running out oil and dispose of environ-
mentally.
Store oil contaminated materials in a separate, specially marked
container and dispose of environmentally.
3.9.4 Cleaning work
Do not perform cleaning work while the motor is running.
Allow the engine to cool down before starting cleaning work.
Do not use gasoline or other easily inflammable substances for
cleaning.
3.9.5 After maintenance work
Reassemble all guards and protections.
Concerning your safety – Maintenance work
DR6X
32
To Next Page
Loading...