Dynapac DR6X - Parking the Machine in Secured Condition

6.4 Parking the machine in secured condition
1. Set the throttle lever to position "MIN" (idle speed).
NOTICE!
Danger of engine damage!
– Do not shut down the engine all of a sudden
from full load speed, but let it idle for about two
minutes.
2. Set the engine stop switch to position "OFF".
ð
The engine is shut down.
3. Park the machine so that it cannot turn over
.
4. Pull the rope by the starter handle, until resistance can be
felt. Guide the starter handle back to initial position.
ð
This procedure protects against moisture deposits inside
the engine.
Fig. 35
Fig. 36
Fig. 37
Operation – Parking the machine in secured condition
DR6X
55