1290 Strain Gage Input Indicator 3
MODEL 1290 QUICK START INSTRUCTIONS
4 STEPS TO GET UP AND RUNNING.
1. MOUNTING
• Prepare panel cutout to dimensions shown here.
• Remove instrument from case with front panel screw.
• Slide rubber gasket over case.
• Slide case through cutout and slide mounting frame over case rear, engaging the detents in the
case. Use a screwdriver to snug the mounting frame to the panel.
2. WIRING
• Connect wires from cable to terminals as indicated in diagram
• Connect AC power as indicated in diagram.
• If applicable, connect alarm(s). Note that alarm defaults are High, Reverse Acting.
To Next Page
Loading...
