Appendix
FlightDEK-D180 Pilot’s User Guide 11-7
Should you experience difficulty with your product that is not solved by reading the troubleshooting section or by
posting on our forum, please call us at (425) 402-0433 or email us at support
@dynonavionics.com. Be sure to have the
FlightDEK-D180‘s firmware version number ready when you contact us. To locate your product’s firmware version,
refer to the Check firmware version section on page 5-10.
See the following list of alert messages displayed by the FlightDEK-D180. The list provides information about what they
mean and what to do about them.
DISPLAYED ALERT MESSAGES
The following table describes the alert messages that the FlightDEK-D180 can display.
Alert Message Description End condition
INTERNAL ERROR
SERVICE UNIT
This error can occur for a few reasons, including
an aborted upload. It signifies that the
FlightDEK-D180 has detected internal problems
in its firmware or calibration tables.
When this error appears, it may be possible to
recover your unit in the field. The best way of
ensuring this is to call Dynon Avionics
immediately. However, there is a good
possibility that the unit will have to be returned
for service.
To Next Page
Loading...
