E-FLITE EFL16575 - SAFE Select Switch Designation BNF

Once bound, the receiver will retain its bind settings for that transmitter until you re-bind.
If the receiver loses transmitter communication, the failsafe will activate. Failsafe moves the throttle channel to low throttle. Pitch and
roll channels move to actively stabilize the aircraft in a descending turn.
If problems occur, refer to the troubleshooting guide or if needed, contact the appropriate Horizon Product Support office.
SAFE Select Technology, Optional Flight Envelope Protection
The BNF Basic version of this airplane includes SAFE Select technology, enabling you to choose the level of flight protection. SAFE mode
includes angle limits and automatic self leveling. AS3X mode provides the pilot with a direct response to the control sticks. SAFE Select is
enabled or disabled during the bind process. With SAFE Select disabled the aircraft is always in AS3X mode. With SAFE Select enabled the
aircraft will be in SAFE Select mode all the time, or you can assign a switch to toggle between SAFE Select and AS3X modes.
Thanks to SAFE Select technology, this aircraft can be configured for full-time SAFE mode, full-time AS3X mode, or mode selection can be
assigned to a switch.
IMPORTANT: Before binding, read the transmitter setup section in this manual and complete the transmitter setup table to ensure your
transmitter is properly programmed for this aircraft.
IMPORTANT: Move the transmitter flight controls (rudder, elevators, and ailerons) and the throttle trim to neutral. Move the throttle to low
before and during binding. This process defines the failsafe settings. You can use either the bind button on the receiver case OR a
conventional bind plug to complete the binding and SAFE Select process.
SAFE® Select Switch Designation BNF
Once SAFE Select is enabled, you can choose to fly in SAFE mode full-time, or assign a switch. Any switch on any channel between 5 and
9 can be used on your transmitter.
If the aircraft is bound with SAFE Select disabled, the aircraft will be in AS3X mode exclusively.
CAUTION: Keep all body parts well clear of the propeller and keep the aircraft securely restrained in case of accidental throttle activation.
The aircraft was bound with SAFE Select enabled.
Your choice for the SAFE Select switch is assigned to a channel between 5 and 9 (Gear, Aux1-4), and travel is set at 100% in each
direction.
The aileron, elevator, rudder and throttle direction are set to normal, not reverse.