Eastron SDM630MCT-ML - Introduction; 1.1 Introduction; 1.2 Product Characteristics; 1.3 Application

SDM630MCT-ML User Manual V1.2
2019 EASTRON ELECTRONIC. ALL RIGHTS RESERVED. www.eastrongroup.com
Content
Chapter 1. Introduction ............................................................................................................ - 1 -
1.1 Introduction ............................................................................................................................... - 1 -
1.2 Product Characteristics ........................................................................................................ - 1 -
1.3 Application ........................................................................................................................... - 1 -
Chapter 2. Technical Parameters ............................................................................................... - 2 -
2.1Technical parameters ................................................................................................................. - 2 -
2.2 Accuracy .................................................................................................................................... - 2 -
2.3 RS485 communication ............................................................................................................... - 2 -
2.4 Performance criteria ................................................................................................................. - 3 -
2.5 Dimensions ................................................................................................................................ - 3 -
2.6 Wiring diagram .......................................................................................................................... - 4 -
2.6.1 Three Phase 4 Wires ........................................................................................................... - 4 -
2.6.2 Three Phase 3 Wires ........................................................................................................... - 4 -
2.6.3 Single Phase 2 Wires ........................................................................................................... - 5 -
2.6.4 Single Phase 3 Wires ........................................................................................................... - 5 -
Chapter 3. Operation ................................................................................................................ - 6 -
3.1 Installation display ..................................................................................................................... - 6 -
3.2 Button Function: ........................................................................................................................ - 6 -
3.3 Measurements .......................................................................................................................... - 7 -
3.3.1 Voltage and current ............................................................................................................ - 7 -
3.3.2 Frequency, Power factor and Demand............................................................................... - 8 -
3.3.3 Power.................................................................................................................................. - 8 -
3.3.4 Energy ................................................................................................................................. - 9 -
3.4 Setup Mode ............................................................................................................................. - 10 -
3.4.1 Password Validation ......................................................................................................... - 10 -
3.4.2 Communication Address .................................................................................................. - 10 -
3.4.3 Baud rate setup ................................................................................................................ - 12 -
3.4.4 Parity setup....................................................................................................................... - 12 -
3.4.5 Stop bits setup .................................................................................................................. - 12 -
3.4.6 CT2 check .......................................................................................................................... - 13 -