Eaton 93E Series - 4.3 Installing Power Terminal Cover Base

Eaton 93E UPS (20–30 kVA, 208/220V) Installation and Operation Manual 164000301—Rev 04 29
Figure 10. Rolling the Cabinet Down the Ramp
44..33 IInnssttaalllliinngg PPoowweerr TTeerrmmiinnaall CCoovveerr BBaassee
NOTE Wiring can be installed between the UPS and accessory cabinets by using conduit or by
routing wiring through the power terminal cover base wiring channels.
To install the Power Terminal Cover Base:
1. Locate the terminal cover base (see Figure 11) from the parts kit.
2. If installing wiring using conduit, proceed to Step 3; otherwise, proceed to Step 4.
3. Punch or drill holes in the bottom of the power terminal cover base (see Figure 11 and Figure 12) for the
AC input, output, bypass, DC input, REPO conduit as required.
4. Using the hardware provided, install the terminal cover base to the back panel of the UPS using the
existing cabinet screw holes (see Figure 12).
5. Proceed to paragraph 4.4 External Battery Cabinet Installation.
UPS System Installation