7 UPS operating instructions
7.1 About UPS operating instructions
This section describes how to operate the UPS.
CAUTION
Before you operate the UPS, make sure that all the installation tasks are
completed and a preliminary startup has been performed by authorized
service personnel. The preliminary startup verifies all the electrical
interconnections to make sure that the installation was successful and
the system operates properly.
Before you operate any of the controls, read these instructions and have
a thorough understanding of the UPS operation.
The UPS is configured to operate with one of the following nominal
voltages: 380, 400, or 415 VAC. Before you start to operate the UPS,
confirm the UPS nominal voltage and frequency from the display by
selecting Settings→Information. If the UPS need to be operated with
another voltage or frequency, contact your closest Eaton office or Eaton
authorized partner.
NOTE: The UPS is not a measuring device. All the displayed measurements are
approximate values only.
7.2 UPS controls and indicators
7.2.1 Control panel
The control panel, located on the UPS front door under a protective hatch door,
contains a color touch screen display. It is used to display the status of the UPS
system and control the operation of the UPS.
© Eaton Corporation plc 2020. All rights reserved. Revision: 001 Document ID: P-164000956 89 (141)
Eaton 93PM G2 UPS 50 – 360 kVA User’s and Installation Guide
To Next Page
Loading...
Need help?
General
