Setting Description
Clock Change the date and time, change the clock format or enable/disable
NTP clock setup.
GSM GSM modem.
Call Service Send automatic e-mail to the service center in case of a failure.
Signal Input Select signal input name and function or change contact polarity.
Relay Outputs Configure the relay outputs.
Battery test Change the power level and duration for battery test.
Bypass Limits Change the bypass voltage or bypass frequency.
Screen Saver
Timeout
Change the screen saver timeout.
Meters Change the meters format.
Lamp Test Enable the lamp test.
HMI backlight Adjust the backlight brightness.
Control P/W
level 1
Change the level 1 password, or remove the password on level 1. The
default value is 1111.
Control P/W
level 2
Change the level 2 password. The default value is 1010.
Reset statistics Reset all statistics.
Minimum
required kVa
Change the minimum required kVa.
User kVa
Configure UPS output kVA rating.
Redundant
level
Configure UPS internal redundancy level.
7.3 Signing in
If the level 1 password is enabled, you need to sign in.
1. Press the lock icon in the top right corner of the screen.
2. Type in your password and press OK.
You are signed in.
© Eaton Corporation plc 2020. All rights reserved. Revision: 001 Document ID: P-164000956 96 (141)
Eaton 93PM G2 UPS 50 – 360 kVA User’s and Installation Guide
To Next Page
Loading...
