7.2.2.2 UPM status color LED indicator
Each UPM has a status LED indicator. It is located on the bottom left corner of
the UPM front panel. The LEDs are red, green and blue (RGB). The color of the
LED shows the state of the UPM. The most urgent state is always the one shown.
Only one color is shown at a time. The table below defines the color coding.
Table 27: Color LED indicators
Color LED
indicators (UPM)
UPM status
UPM starts up
UPM in online, battery or EnergyAware mode
UPM in stand-by, ESS or VMMS mode
UPM in shutdown state with active alarm(s)
UPM in all other states with active alarm(s)
© Eaton Corporation plc 2020. All rights reserved. Revision: 001 Document ID: P-164000956 92 (141)
Eaton 93PM G2 UPS 50 – 360 kVA User’s and Installation Guide
To Next Page
Loading...
