Eaton 9PXM - Rack-Mount Installation

12 4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 09
1. Select the location for the brackets at the floor intersection beside the intended cabinet location.
2. Attach the brackets to the cabinet base as shown in Figure 9 .
3. Roll the UPS cabinet to its intended location. Position the rear section of the cabinet base under the open
ends of the stabilizer brackets as far as the cabinet will go.
4. Turn all four leveling feet counter-clockwise until the cabinet is level.
5. Using the proper type of customer-supplied screws for the intended mounting surface, attach each
bracket as shown in Figure 9 . All screws must be properly driven into the structural material.
Figure 9. Floor Anchor Bracket Installation
Floor Anchor
Bracket
Floor Bolt
Slots
Mount Bolts
Spacer
Leveling
Foot
*Installation to be updated
(spacers/bolts)
22..66 RRaacckk--MMoouunntt IInnssttaallllaattiioonn
CAUTION
The 12-slot UPS weighs 93 kg (204 lb) with the caster cart. Install the cabinet in the rack before installing power
and battery modules and before making connections to the intended power source.
The Eaton 9PXM UPS and the battery cabinet are very heavy with power modules and two battery modules per
slot installed. If installed, before moving the cabinets, remove the power modules and battery two battery
modules per slot (see “9.1 Routine Maintenance ” ).
Rack-Mount Installation