4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 09 77
Figure 58. Display Status Indicators
Indicator Status Description
Standby Mode
The UPS is Off, waiting for startup command
from user. The
indicator flashes
continually.
Equipment is not powered until button is
pressed.
Green LED blinking when UPS is
in Standby mode.
Online Mode
The UPS is operating normally. The
indicator is on steady.
The UPS is powering and protecting the
equipment.
Battery Mode
1 beep every 10 seconds
A utility failure has occurred and the UPS is on
Battery mode.
The UPS is powering the equipment with the
battery power.
Prepare your equipment for shutdown.
End of Backup Time
1 beep every 3 seconds
The UPS is on Battery mode and the battery is
running low.
Low Battery Warning settings: [Capacity] [0%]...
[100%]
[Runtime] [0mn]...[60mn]
The alarm triggers when the set percentage of
battery
capacity or remaining back-up time is reached.
High Efficiency Mode
The UPS is operating on High Efficiency mode. The UPS is powering and protecting the
equipment
Bypass Mode
An overload or a fault has occurred, or a
command has been received, and the UPS is in
Bypass mode.
Equipment is powered but not protected by the
UPS.
77..1144 CChhaannggiinngg PPaarraammeetteerr SSeettttiinnggss
The LCD display menus can be selected to show measurements, change control settings and show UPS and
event logs. Use the two middle buttons (
and ) to scroll through the menu screens then press the Enter (
) button to select an option (see Figure 60 ).
77..1155 DDiissppllaayy MMeennuu SSccrreeeennss
The figures in this section show the available menu selections from the control panel.
Start Screen
The start screen shows the required information at first startup.
Changing Parameter Settings
To Next Page
Loading...
