Eaton 9PXM - Figure 43. EBM to UPS Connections

4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 09 51
CAUTION
Make sure all AC power is removed from the UPS. Observe all electrical safety precautions.
4. Push in the EBM DC emergency disconnect switch on the rear EBM panel and turn the switch lockout key
(see Figure 48 ).
NOTE The UPS and EBM AC/DC terminal covers are shipped in the UPS and EBM accessory
kit and do not come installed on the UPS or EBM chassis.
Figure 43. EBM to UPS Connections
EBM Terminal
Covers
UPS DC
Terminal
Cover
DC Emergency
Disconnect
Switch
Communication
Ports
EBM UPS
EBM Installation Wiring Options
Connect the AC cables to the applicable terminals by inserting the ends into the AC terminal block and tighten
the screws depending on the EBM configuration option as follows:
1. Route the EBM DC input/output and the AC input cables to the terminal blocks as shown in (Figure 44).
Connected Battery Cabinet Option