4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 09 39
44..22 UUPPSS EElleeccttrriiccaall IInnssttaallllaattiioonn
WARNING
Only qualified service personnel (such as a licensed electrician) should perform the electrical installation. Risk of
electrical shock.
CAUTION
To prevent electrical shock or damage to the equipment, verify that the Eaton 9PXM UPS is OFF before you
remove the terminal covers. The circuit breaker or disconnect switch must also be OFF at the AC input service
panel.
To install the UPS without an external bypass switch:
1. Install the AC terminal upper covers supplied in the accessory kit of the UPS (See Figure 33 ) . The AC
input terminal block is located on the lower right side and the AC output on the upper right side of the UPS
rear panel.
UPS Electrical Installation
To Next Page
Loading...
