36 INSTALLATION AND OPERATION MANUAL 25-16330-B December 2019 www.eaton.com
Commissioning the panel
Figure 6. Device Outputs
Sounder Trigger
The output device can be programmed to respond to a specific trigger – globally, by
zone, by address or by panel.
Delay Configuration
The output of a device when triggered can be delayed – based on a user defined
value in minutes.
This programming option is enabled when a value other than zero is entered inside
the ‘Delay’ window.
MCP Override
This option is a manual intervention override. When enabled, the delay can be
overridden from any call point on the loop when triggered.
Allocation List
If the sounder trigger is by address, zone or panel, then the trigger source can be
selected from the Allocation List box.Panel outputs
To Next Page
Loading...
