95INSTALLATION AND OPERATION MANUAL 25-16330-B December 2019 www.eaton.com
Appendix
Got to it
4 Way Sounder Controller
To install the device
1. Remove the cover of the unit.
2. Fit the back-plate in position and pass the wires into it taking care not to
damage the circuit board.
3. Connect the unit according to the diagram below.
ote: N No addressing of the interface is required. See control panel operation for
details. This unit requires a permanent 230V AC supply.
Figure 62. 4 Way Sounder Controller
otes: N
1. Only connect cable screen to its adjacent earth terminal.
2. The end of line resistors must always be fitted, even if the sounder circuits
are unused
To Next Page
Loading...
