73INSTALLATION AND OPERATION MANUAL 25-16330-B December 2019 www.eaton.com
Panel Controls and Indicators
Device Config (Add Device)
The Add Device screen is accessed as shown below. The screens are accessed from
the healthy screen by first pressing any button. You will then be prompted to enter
the passcode which will show the screen below by default.
Press OK and scroll through the list of events using the Up and Down arrow buttons.
Figure 40. Device Config (Add Device) screen
ote: N After a device has been found and
added to the panel, the engineer
should perform a hard reset of the
panel to finish the function.
To Next Page
Loading...
