Eaton CF2000 - Panel Controls and Indicators; Control Panel Overview

39INSTALLATION AND OPERATION MANUAL 25-16330-B December 2019 www.eaton.com
Panel Controls and Indicators
Panel Controls and Indicators
Panel Overview
Buzzer (Not shown) - An intentional buzzer
‘intermittent’ signal is used to indicate the
disablement & test condition
Panel Display
❶ LCD Display
❷ System LEDs
❸ Zonal LEDs
❹ Buttons
LED Display
LED Name Function Action
①
Power On Shows Panel is on (Mains Healthy) Check Indicator is Illuminated
②
Fire Indicator Panel has Detected a Fire Implement Fire Action Procedure
③
General Fault Monitors devices for faults e.g.
Smoke detectors/Sounders
Report to System Supervisor
④
General Disable Monitors panel for disablements Report Fault to Service Dept
⑤
Test Supervisor/Engineer is testing
the system
Check with System Supervisor
⑥
Delay Active Part of the system has
been disabled
Check with System Supervisor
⑦
FRE On Fire Routing Equipment
relay activated
Report to System Supervisor
⑧
FPE Indicates Fire Protecting
Equipment status
Check with System Supervisor
⑨
Power Fault Indicates PSU fault Check with System Supervisor
⑩
Sounder Indicates the Sounder status Check with System Supervisor
⑪
FRE Indicates Fire Routing
Equipment status
Check with System Supervisor
⑫
System Fault Panel has a fault Report to System Supervisor