77CF3000 INSTALLATION AND OPERATION MANUAL 25-14682-A July 2019 www.eaton.com
Panel controls & indicators
Weekly test
To activate the touch screen, touch the top left corner of the screen until the screen
illuminates. To enter the supervisor mode touch the supervisor button and enter the
passcode. Select the others tab as shown below. Press Weekly test.
Weekly test is now in progress.
The weekly test will ask the user to carry out a reset on completion of
the callpoint operation.
Evacuate
Silence
Alarms
Mute
Buzzer
Reset
Others
Enable/Disable
View Log
Check Config.
Print
Lamp test
View Fires
AC = 19
Pre
Alarms
Disabled
Faults
Weekly Test
Supervisor
FRE off
Supervisor
FRE off
Weekly test
Do you want to continue?
* Features outside EN54 Spec
Yes
No
Weekly test
Awaiting Alarm Signal
Will reset after 4 minutes
Cancel
To Next Page
Loading...
