Eaton Fuller AT-1202 - How to Remove the Output Shaft and Reduction Gear Assembly

Removal and Disassembly
21
Removal and Disassembly
How to Remove the Output Shaft and Reduction Gear Assembly
Special Instructions
None
Special Tools
• Typical service tools
Procedure -
1. Use a soft bar and maul to drive the output shaft forward and
from the rear bearing assembly.
1. Sliding Clutch
2. Mainshaft
3. Reduction Gear
4. Bearing
5. Snap Ring
6. Washer
7. Nut
1
2
3
4
5
6
7