Eaton Fuller AT-1202 - How to Assemble the Output Shaft and Reduction Gear

Assembly and Installation
39
Assembly and Installation
How to Assemble the Output Shaft and Reduction Gear
Special Instructions
None
Special Tools
• Typical service tools
Procedure -
1. Install the reduction gear bearing in the hub of the reduction
gear with snap ring in the bearing facing up. Use a bearing
driver or tap carefully on the outer race of the bearing with a
soft bar.
2. Install the snap ring in the groove in the hub of the reduction
gear.
3. Mark any two teeth on the reduction gear and then mark the
two teeth directly opposite.