Eaton Fuller AT-1202 - How to Install the Companion Flange or Yoke

Assembly and Installation
53
Assembly and Installation
How to Install the Companion Flange or Yoke
Special Instructions
None
Special Tools
• Typical service tools
Procedure -
1. Install the yoke or flange on the input shaft and install the
washer and elastic stop nut on the threads of the input shaft.
2. On units not equipped with a speedometer drive gear, install
the spacer on the output shaft and in the rear bearing hous-
ing.
3. Install the yoke or flange on the output shaft and install the
washer and elastic stop nut on the threads of the shaft.