Eaton Fuller AT-1202 - How to Assemble the Front Bearing Housing Assembly

Assembly and Installation
36
How to Assemble the Front Bearing Housing Assembly
Special Instructions
None
Special Tools
• Typical service tools
Procedure -
1. Install the rear bearing on the input shaft against the shoul-
der on the shaft.
Note: Heating of the bearing will faciliate installation. Do not
heat the bearing over 275 °F.
2. Install the snap ring in the groove on the input shaft.
3. Install the front bearing in the bearing housing with a bear-
ing driver or by tapping carefully on the bearing inner race
with a soft bar.