Assembly and Installation
37
Assembly and Installation
4. Install the front bearing retaining snap ring in the groove in
the housing. Make sure that the snap is in the groove and not
just against the shoulder in the housing bore.
5. Use an oil seal driver to install the front oil seal. The side of
the oil seal with the seam should face into the housing, and
the front of the seal should be flush with the face of the
housing.
6. Install the front bearing housing on the front case studs with
the oil feed port on the mounting surface of the bearing
housing aligned with the oil port in the front of the case. Se-
cure with the six nuts and lockwashers.
To Next Page
Loading...
