INSTALLATION
EATON Powerware
®
5125 (9910-E65) UPS Installation Guide for IBM
®
Applications S 164201698 Rev 1
11
12. Loosen the wing nuts on the rear hold-down bracket and slide the
bracket into the slot on the UPS rear panel.
Verify that the rear hold-down bracket is fully seated and then
tighten the wing nuts.
Wing Nuts on Rear
Hold-Down Bracket
(attached to rail)
Rear Hold-Down Bracket
(for UPS)
Figure 8. Securing the Back of the UPS
To Next Page
Loading...
