INSTALLATION
EATON Powerware
®
5125 (9910-E65) UPS Installation Guide for IBM
®
Applications S 164201698 Rev 1
16
UPS Installation
NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur to
your equipment and void your warranty.
To install the UPS:
1. If you are installing power management software, connect your
computer to the USB port, UPS communication port, or optional
X-Slot
®
card (see Table 10 on page 35). For the communication port,
use only the serial cable supplied in the E65 accessory kit.
2. If your rack has conductors for grounding or bonding of ungrounded
metal parts, connect the ground cable (not included) to the ground
bonding screw.
Load Segment
Circuit Breakers
USB Port
Battery Connector
Communication
Port
Battery Circuit Breaker
IEC 320-C19 Receptacles
L6-30 Receptacle
IEC 320-C13
Receptacles
Power Cord (0.9m/3 ft)
with L6-30 Plug
X-Slot
Communication
Bay
Ground
Bonding Screw
REPO Port
Figure 14. UPS Rear View
3. If an emergency power-off (disconnect) switch is required by local
codes, see the following section, “Remote Emergency Power-off
Installation” to install the REPO switch before powering on the
UPS.
4. Continue to “Power Connections and Startup” on page 19.
To Next Page
Loading...
