Eaton Powerware 5125 - Installing the Internal Batteries

INSTALLATION
EATON Powerware
®
5125 (9910-E65) UPS Installation Guide for IBM
®
Applications S 164201698 Rev 1
13
Installing the Internal Batteries
CAUTION
The UPS battery trays are heavy (20.5 kg/45 lb). A minimum of two people a re required to lift
the battery trays into the UPS chassis.
To install the battery trays into the UPS chassis:
1. Locate the cartons labeled “Battery Tray” (IBM PN 39J4828).
2. Verify that the battery circuit breaker on the UPS rear panel is in the
OFFposition(seeFigure13onpage15).
3. Unscrew and set aside the battery retaining bracket (see Figure 10).
Battery Retaining Bracket
Figure 10. Removing the Battery Retaining Bracket
4. Slide the battery trays into the chassis (see Figure 11).
Figure 11. Installing the Battery Trays
5. Secure the battery trays to the chassis with the battery retaining
bracket and screws removed in Step 3.