JOINING THE CABINETS
EATON Powerware
®
9355 UPS (20/30 kVA) Installation and Operation Manual S 164201626 Rev B www.powerware.com
18
Edge Grommet for
Options Cabinet
EBC Options Cabinet UPS
Figure 10. Joining Additional Cabinets (Typical Configuration)
11. Remove the two ground straps from the rear panel of the EBC or Options
Cabinet (installed at the top corners).
12. Install one ground strap between the r ear panels of t he adjacent cabinets as
shown in Figure 11.
13. Install the other ground strap between the front panels of the adjacent cabinets
as shown in Figure 11.
14. Repeat Steps 11 through 13 for each cabinet.
15. Replace the front door of all cabinets.
16. Continue to “Electrical Installation” on page 21.
To Next Page
Loading...
