Eaton Powerware 9355 - 7 Permanent Mounting Installation

EATON Powerware
®
9355 UPS (20/30 kVA) Installation and Operation Manual S 164201626 Rev B www.powerware.com
45
Chapter 7 Permanent Mounting Installation
NOTE Permanent mounting is optional and uses the rear shipping bracket.
To permanently mount the cabinet(s):
1. Lower the leveling feet to prevent the cabinet from rolling.
Figure 30. Lowering the Leveling Feet
2. Attach the rear shipping bracket to the bottom of the cabinet rear panel using the
retained hardware from the shipping pallet (see Figure 31).
3. Install customer-provided floor bolts in the holes in the bottom of the bracket to
attach the cabinet to the flooring.
4. Continue to one of the following sections:
S “Communication” on page 47 to install UPS communication options, such as
X-Slot cards or remote emergency power -off (REPO).
S “Operation” on page 67 to start up the UPS.