Eaton Powerware 9355 - 8 Communication

EATON Powerware
®
9355 UPS (20/30 kVA) Installation and Operation Manual S 164201626 Rev B www.powerware.com
47
Chapter 8 Communication
This section describes the:
S DB-9 communication port
S X-Slot cards
S Remote Monitor Panel (RMP) and Industrial Relay Card (IRC)
S Powerware LanSafe
®
Power Management Software
S Remote emergency power-off (REPO)
S Relay output contacts
S Programmable signal inputs
Figure 32 shows the location of the communication options and control terminals on
the UPS.
DB-9 Communication Port
REPO (normally open)
Signal Input 2
Signal Input 1
X-Slot
Communication
Bay #2
X-Slot
Communication
Bay #1
Relay Output Contacts
Control
Terminals
REPO (normally closed)
Pull-Chain Output
Contacts (parallel only)
Figure 32. Communication Options and Control Terminals