XS series operating manual
XS user manual v0.55 - 130 -
Advices and programming examples
In order to help you writing control software for the XS series, we provide a training software
XSCom.
The XSCom software gives you the possibility to fully control all the unit functions in following step
by step all the detail exchanges between the PC and the measurement device.
This training software has been written in three languages: Delphi ( pascal ) , C++ Builder (C++)
and Visual basic.
Source codes are provided with many comments.
For more detail, refer to the XSCom files on the CD.
To Next Page
Loading...
Need help?
General
