Note:
After the mouse stays on the relevant parameter options for a while, the
corresponding setting prompt will pop up automatically.
Key option description:
1. Layer height: the height of each layer printed, the smaller the print surface is finer,
but the slower it is, the parameter range is 0.5-3, Eazao Zero uses 1.5 nozzles by
default.
2. Wall thickness: the thickness printed on the outer surface of the model. Setting 3
here means that the outer surface will print a layer.
3. Top/Bottom Thickness: Determines the thickness of the bottom/top of the model.
4. Filling Density: Determines the degree of density of the mesh fill inside the model,
generally set below 15%.
5. Print temperature: Set 0 ° C here.
6. Speed: The speed is set to 23mm/s.
7. Platform Attachment Type: Select Skirt here to print an outer circle on the bottom
of the print model.
8. Spiral print outer contour (ie vase mode): only the outer surface and bottom
of the model are printed. When the outer surface is printed, the spiral is lifted
continuously, which can improve the surface quality, but it has requirements for the
model. The model is required to have only one outer surface.
PRINTING
25
To Next Page
Loading...
