Eazao Zero - Servicing; Servicing Your Eazao Zero; Extruder Cleaning; Electric Putter Cleaning

Exit complete
SERVICING
1. Disassemble the extruder: rotate the motor part of the extruder and pull out the
screw.
2. Clean the clay inside the extruder sleeve, clean the screw clay, clean the oil seal and
seal plug clay.
3. Immerse the clay tube in water and seal it, seal the clay outlet of the cartridge and
place it in a cool place.
5.1 Servicing your Eazao Zero.
5.1.1 Extruder cleaning.
5.1.2 Electric putter cleaning.
If the clay is used up, please refer to this step to return the electric putter to its original
place and clean it: page 31
5.1.4 Introduction of electric putter "extrusion" interface.
1.Click continuously to make it 2000.
2.First click "BackPutter", then click "Out", until the thrust block returns to the motor,
click "ShutDown".
1
2
30